Inspectors ensure that structures and plumbing and mechanical systems are built according to approved plans and properly located on a parcel.
Inspections are generally conducted between 8:30 a.m. and 4:00 p.m. Monday through Friday. We do not have morning or afternoon scheduling, nor do we do inspections by appointment. Inspection timing is based on geographic routing to provide the best overall service levels.
Note: A Pre-Erosion (410) inspection must be scheduled and performed PRIOR to scheduling a Footing Steel (110) and/or Zoning Setback (130) inspection. Upon re-inspection, failure to comply with the first correction notice will result in a fee of $148.00. Failure to comply with subsequent re-inspections will result in a $296.00 fee each.
You may request an inspection online or by phone. Inspection requests must be made by 10 p.m. the day before the requested inspection.
Phone - Our IVR system is available for scheduling inspections for both systems. For permit types and inspection codes, use our step-by-step guides: IVR Guide for CC LMS or IVR Guide for Tidemark. The IVR will route your inspection request to the correct system. To request an inspection by phone, call 360.397.2477 and provide the following:
- Name and phone number
- Permit/Case number
- Inspection code listed on your permit
- A short message for your inspector, if necessary
Online - use the table below to determine which online inspection request system you should use.
|Request an inspection|
|IVR Guide||IVR Guide|
Alternative inspection services
Status and results
You may contact your inspector after 9 a.m. for an approximate inspection time. We try to complete all requested inspections daily, but this is not always possible.
Visit our Permit Status page to see the status of your permit and inspection information.
Use this map to determine the inspector for your area.
To contact your inspector, call 564.397.4912.